Looking for:
Connect fittings and components in Tube and Pipe | Inventor | Autodesk Knowledge Network.- Solved: Tube & Pipe Issue (Connect Fittings) Inventor - Autodesk Community
For instance, with a run active, routes can be populated and deleted, while with either a run or a route active, library fittings can be placed onto the route segment from the Content Center using AutoDrop. To activate the edit environment for appropriate tube and pipe documents such as master runs assembly, run, and route, do either of the following in the Model browser:. After completing the edits, you can leave the edit environment using any of the following ways depending on specific needs:.
The last active document before entering into the current environment is activated. The parent document of the current edit environment is activated. The base environment is activated. The Wyalo library parts will appear in the same columns in your partlist and BOM as the other Content Center files and they use the same Iproperties. Installing a Wyalo Content Center library is very easy: place the. Try for free Try this library for free without time limitations and see for yourself if it meets your requirements.
And if you have any questions: don't mind to ask! There is also a full range version: The full version of this library contains all available diameters of these 43 parts more than 1, unique 3D models. For more information: Click here. Use to navigate. Pipe runs can be placed in any other Autodesk Inventor add-in application assembly.
The main master runs assembly and all that it contains is read-only. In the graphics window, the outline of the tube and pipe component is visible, but the component cannot be edited. New tube and pipe components cannot be added. Tasks you can perform include:.
Note: For additional information on assemblies, refer to the Autodesk Inventor table of contents, Build Assemblies section. Which tasks are performed with tube and pipe features? Use the features added by the run environment to: Create and modify styles that conform to industry standards. Add one or more routes to the run. Place fittings from the active project work space into routes and runs. Connect two components relative to one another in the tube and pipe assembly. Populate all routes or selected routes.
Place library fittings and conduit parts from the Content Center using AutoDrop on to routes and runs. Refresh library components to ensure they are up to date in the Content Center. Use the Parameters command to maintain model parameters and user parameters so as to assist in route design.
No comments:
Post a Comment